There are a number of factors that determine the cost of an irrigation system, including number of zones determined by landscape layout, water pressure and flow. While not all cases are the same, the typical cost ends up being between $750 -$850 per zone on systems with a minimum of three zones.
No, irrigation and landscape lighting is all we do. We do however work alongside some of Calgary’s best landscapers, and would be happy to refer you to them.
Usually the installation takes only one day, but in some cases additional time may be necessary
No. — In fact, an automatic sprinkler system may actually save you water. A well designed, efficient irrigation system applies exactly the amount of water needed by your landscape.
We install our pipe with a vibrating plough that’s minimally invasive to sod. Sod at sprinkler heads and pipe connections is carefully replaced afterwards. We take pride in our ability to install a system and make it seem like no one was ever there.
An automatic sprinkler system will do a more efficient job because it will be designed based on your landscapes diverse watering needs, using specific products designed to water grass, trees, shrubs or garden plants.
Certainly. We specialize in pump drawn systems for well-derived water supplies. With today’s advanced technology, there are numerous options available.
Our service schedule includes a spring turn-on and a winter shut-down. We will contact you to schedule both of these appointments.
The installation of an automatic rain sensor is standard on systems we install and will ensure that after rainfall has accumulated, the system will temporarily stop the automatic watering cycle.
No permits are required for the installation of a lawn sprinkler system in Calgary.
Installation can take place whenever frost is out of the ground – typically from April to October. However installations can take place at any time.
Possibly. In fact, it could cost you more money in the long run. A professionally installed irrigation system will be designed and installed using the most cost-effective and energy-efficient methods possible.
Turn Controller to off. Then locate water shut off in the basement. Turn handle from parallel to water line to 90 degrees perpendicular to water line.